|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Sep 2020
Posts: 26
Rep Power: 6 ![]() |
Hello,
Can anyone explain what k- omega stabilization (T 41) signifies? What would happen if one turn it on, when to turn it on or should one turn it on ? Thanks. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Hans Bihs
Join Date: Jun 2009
Location: Trondheim, Norway
Posts: 405
Rep Power: 19 ![]() |
Stabilization follows the ideas outlined by the SST type models, i.e. avoiding negative or zero model quantities.
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Calculate k and omega of a freestream flow over VAWT | studente | OpenFOAM Pre-Processing | 0 | July 24, 2021 12:15 |
Diffenence between omega_ and omega_() | Youwu | OpenFOAM Programming & Development | 1 | July 24, 2020 07:50 |
[solids4Foam] How to calculate drag coeff when using solids4Foam | amuzeshi | OpenFOAM CC Toolkits for Fluid-Structure Interaction | 15 | November 7, 2019 13:50 |
Behaviour of the kOmegaSST in a steady-state case | Max1234 | OpenFOAM Running, Solving & CFD | 18 | October 31, 2018 09:03 |
how to calculate the omega at inlet boundary in k omega sst | Scabbard | OpenFOAM Running, Solving & CFD | 2 | September 30, 2014 14:06 |