Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: jchan033

Forum: ANSYS Meshing & Geometry

January 16, 2017, 00:40

Replies: 6

[ICEM] Meshing a 'high angle ratio' triangular surface

Views: 1,072

Posted By jchan033

I've tried editing the geometry...but I think its...

I've tried editing the geometry...but I think its the nature of the geometry that causes this difficult meshing.

It's a curve, so like a circle, it will slowly go to an angle less than 18 at some...

Forum: ANSYS Meshing & Geometry

January 15, 2017, 22:34

Replies: 6

[ICEM] Meshing a 'high angle ratio' triangular surface

Views: 1,072

Posted By jchan033

But in the end I still need to settle with a...

But in the end I still need to settle with a rectangular block of..."high parallel length ratio", which will lead to a very small minimal angle (fluent takes 18 degrees or more yes?)

Is there any...

Forum: ANSYS Meshing & Geometry

January 14, 2017, 09:04

Replies: 6

[ICEM] Meshing a 'high angle ratio' triangular surface

Views: 1,072

Posted By jchan033

Hi Antanas, Thanks for responding! The...

Hi Antanas,

Thanks for responding!

The attached is the result of your recommendation; any more advice you think would help? It still is skewed quite a lot.

Cheers,
Simon

Forum: ANSYS Meshing & Geometry

January 13, 2017, 09:35

Replies: 6

[ICEM] Meshing a 'high angle ratio' triangular surface

Views: 1,072

Posted By jchan033

Meshing a 'high angle ratio' triangular surface

Hi everyone,

As the subject indicates I wish to mesh a triangular surface (currently working on 2D), but because my triangle has a high 'angle ratio', meshing it creates very skewed cells.

I am...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 18:33.