Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Far

Forum: ANSYS Meshing & Geometry

March 24, 2012, 10:47

Replies: 6

[ICEM] Blocking strategies for eight little holes

Views: 2,137

Posted By Far

Oh yes, You are 100% correct. I didn't check the...

Oh yes, You are 100% correct. I didn't check the premesh, just created blocking. So when turned on the premesh, I get the mess and after adding the ending surfaces mesh is OK as it should be.

I...

Forum: ANSYS Meshing & Geometry

March 24, 2012, 10:05

Replies: 6

[ICEM] Blocking strategies for eight little holes

Views: 2,137

Posted By Far

No, I didn't get the problem.

No, I didn't get the problem.

Forum: ANSYS Meshing & Geometry

March 22, 2012, 23:00

Replies: 6

[ICEM] Blocking strategies for eight little holes

Views: 2,137

Posted By Far

Main Command: Extrude along curve (provide...

Main Command: Extrude along curve (provide appropriate face, one curve from starting surface to ending surface, end point of that curve). split should run across all blocks (vertically) for efficient...

Forum: ANSYS Meshing & Geometry

March 22, 2012, 15:00

Replies: 6

[ICEM] Blocking strategies for eight little holes

Views: 2,137

Posted By Far

If you can attach the tin and blk (on forum or...

If you can attach the tin and blk (on forum or through pm), then I can suggest you something.

Forum: ANSYS Meshing & Geometry

March 22, 2012, 14:28

Replies: 6

[ICEM] Blocking strategies for eight little holes

Views: 2,137

Posted By Far

That's the method, you have already figured it...

That's the method, you have already figured it out. Use o block for each 7 holes (Edit: Apply O-block for eight holes). Check this out http://www.youtube.com/watch?v=KabKFrJK3fM&feature=related

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 03:56.