|
[Sponsors] |
July 29, 2000, 16:25 |
help needed: cone-shape surface
|
#1 |
Guest
Posts: n/a
|
Hello, there, I am new user of Star-CD.
I want to generate a cone-shape surface(or patch) through Star-CD. What procedue should I follow? The equation of the surface in cylinder coordinate is z = a*r, theta belong to [0,2Pi], a is a constant. Thanks, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
drag of cone | Ebrahim | FLUENT | 2 | March 19, 2008 05:21 |
Help needed with free surface simulation | Mark | CFX | 4 | October 27, 2006 12:07 |
surface shape chanes by deposit | Zhou | FLUENT | 0 | June 12, 2005 05:14 |
Nose-Cone | PAUL MERRILLS | Main CFD Forum | 0 | May 20, 2000 08:44 |
Problems meshing a pie-shape cross-section bar-suggestions or workarounds needed | Ricky Wong | FLUENT | 1 | May 11, 2000 17:35 |