|
[Sponsors] |
October 26, 2000, 05:31 |
negative volume
|
#1 |
Guest
Posts: n/a
|
Dear people
I have meshed one quarter of rectangular duct canal with vertices than in form of block, but in the cell check I become the error negative geometry. How I can rectify this error thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Negative volume | Mahbub | Siemens | 7 | April 28, 2011 08:04 |
Negative Volume in CFX | Barbara | CFX | 2 | January 10, 2008 10:19 |
Help: Negative Volume | MANOJKUMAR | FLUENT | 8 | December 24, 2005 04:59 |
negative volume | Avesta | FLUENT | 2 | June 19, 2004 06:34 |
Negative Volume | sen | Siemens | 2 | January 18, 2001 23:43 |