How to put two models together

July 12, 2002, 09:29

I've two models. One is the inlet duct of a pump, the other is the inlet volume iside the pump.

So far, I've worked with the separetly: two models, two meshes, two simulation.

How can I put them together in one mdl file?

Geometries are very complex, so I cannot rebuild one of them in the other's mdl file.

July 15, 2002, 07:03

Just search a little bit in this forum. It was discussed some time ago. (cdsave, cwri, vwri, cpwri, cread, vread, cpread). Or use the databases in proam.

July 12, 2002, 09:29	How to put two models together	#1
Franch Guest Posts: n/a	I've two models. One is the inlet duct of a pump, the other is the inlet volume iside the pump. So far, I've worked with the separetly: two models, two meshes, two simulation. How can I put them together in one mdl file? Geometries are very complex, so I cannot rebuild one of them in the other's mdl file.

July 15, 2002, 07:03	Re: How to put two models together	#2
Joern Beilke Guest Posts: n/a	Just search a little bit in this forum. It was discussed some time ago. (cdsave, cwri, vwri, cpwri, cread, vread, cpread). Or use the databases in proam.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two-fluid models vs mixture models for bubbly flows	Hansong Tang	Main CFD Forum	6	December 8, 2009 04:21
MODELS	Murthy V N	FLUENT	0	February 9, 2008 02:48
LES models	fran	Main CFD Forum	1	August 25, 2005 07:44
MRF and DPM models	you	FLUENT	0	June 8, 2001 06:49
...models...	Dia Zeidan	Main CFD Forum	2	February 9, 2001 13:54