|
[Sponsors] |
May 15, 2003, 05:12 |
Couples usage in engine moving mesh
|
#1 |
Guest
Posts: n/a
|
I have a IC Engine 3D moving mesh. Valve port and valve mesh structures are different, which forces me to use arbitrarycouples between these meshes. But I get a lot of warnings as *** WARNING #007 *** SETTING T AT CELL ***** FROM -2.795E+02 TO 0.01*TREF FOR DENSITY CALCULATION
and all the cell numbers indicated are some of those near the couple boundary. After 2 or 3 time steps, the solution shows negative densities. PS: The analysis ran successfully when I used perfectly merged identical valve and port mesh structures. Any clarification is appreciated. Regards, Alfred Herman |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh engine for several software | jecil | Main CFD Forum | 8 | January 18, 2012 05:27 |
Moving Reference frame - UDF - Moving mesh | modisa | FLUENT | 0 | April 18, 2008 14:31 |
Need help to mesh Wankel engine | Sam | Main CFD Forum | 3 | October 4, 2007 21:33 |
CFD on a simple moving engine | shreen | Main CFD Forum | 3 | December 7, 2005 13:07 |
define moving mesh for engine step by step | homan | FLUENT | 0 | October 26, 2005 04:27 |