 |
 |
 |
|
|
|
[Sponsors] | ||||
July 7, 2004, 06:17
|
How to get convective flux
|
#1 |
|
Guest
Posts: n/a
|
The GETC FLUX command loads only mass fluxes and occupies all 6 registers. Then, the FLUXSUM command calculates mass flux only. How can I get convective heat flux (or scalar flux) through channel cross-section? Thanks. Can someone explain what are the 6 components of mass flux and is there any use to operate with them?
|
|
|
||
|
July 9, 2004, 00:21
|
Re: How to get convective flux
|
#2 |
|
Guest
Posts: n/a
|
try getw instead of getc
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| uds self-programed convective flux | carsten conzen | FLUENT | 0 | December 15, 2004 07:49 |
| convective heat flux | zhujg | Phoenics | 1 | December 11, 2003 17:41 |
| convective flux | Annabelle Joulin | FLUENT | 0 | December 10, 2003 11:54 |
| UDS - Convective Flux | Victor | FLUENT | 2 | October 8, 2003 08:26 |
| the calculation of convective flux | Hai-Wen Ge | Main CFD Forum | 14 | April 23, 2001 07:34 |
Linear Mode
