 |
 |
 |
|
|
|
[Sponsors] | ||||
August 27, 2004, 22:22
|
SST model help please!
|
#1 |
|
Guest
Posts: n/a
|
Hi,
does anyone know whether ED corresponds to e from k-e or w from k-w model in the user subroutines when using SST model? I was told ED is output as w in such case, but my results suggest differently. And as SST is a combination model of both k-w and k-e, it is possible that the subroutines actually give outout ED as e....? Thanks, Sheila |
|
|
||
|
September 6, 2004, 22:34
|
Re: SST model help please!
|
#2 |
|
Guest
Posts: n/a
|
Not sure but most likely w. If you don't mind, can u tell me how did u activate the SST model i.e the procedure to activate this SST model in Star?
|
|
|
|
||
|
September 6, 2004, 22:39
|
Re: SST model help please!
|
#3 |
|
Guest
Posts: n/a
|
Nevermind, just saw the procedure in supnotes.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Population balance model for twofluid model | pierre | OpenFOAM Running, Solving & CFD | 9 | March 19, 2016 13:46 |
| Surface Reaction Model or Heterogeneous Rxn Model? | satheeskannan | FLUENT | 0 | September 2, 2008 18:55 |
| changing model constants in k-e turbulence model | Sunil | CFX | 3 | October 3, 2006 12:12 |
| Symmetry model half or total geometrical model in LES | vvqf | OpenFOAM Pre-Processing | 3 | March 22, 2006 09:06 |
| Copying boundary conditions from model to model | Lior | FLUENT | 3 | September 23, 2004 16:10 |
Linear Mode
