|
[Sponsors] |
September 20, 2005, 20:43 |
error reading file
|
#1 |
Guest
Posts: n/a
|
when i finished transient simulation, i try to read the pstt, but the error #250 happaned. i ran the trasient simulation after i have finished steady state running. how can i settle the problem?
|
|
September 21, 2005, 10:13 |
Re: error reading file
|
#2 |
Guest
Posts: n/a
|
It seems to be that your *.pstt file exeeds the size of 2 GB. Belonging to 32bit OS there is no remedy for this.
Instead of using the pstt file define a Backup-Frequenz in NavCenter, E.g. every 5 timesteps. Then star writes out a *.pst_<timestep> file, which is simply a *.pst file for that timestep. |
|
September 21, 2005, 12:11 |
Re: error reading file
|
#3 |
Guest
Posts: n/a
|
I did this by accident myself once, wrote a transient file larger than 2 GB. I used the utility star convert under the tools>convert>star convert drop down menu. Under Post file type select transient and that allows you to specify the number of time steps for the new file. Under output file type select binary again and give it a new name with the pstt extension. Then hit apply. Just a typical warning, make sure you make a backup of the file before you start messing with it. If you end up needing to run it again you can run for fewer time steps (a size you can open) and then restart off that file for the next set of time steps.
Tom |
|
September 21, 2005, 21:31 |
Re: error reading file
|
#4 |
Guest
Posts: n/a
|
thanks a lot.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error Reading date file | chnrdu | OpenFOAM Running, Solving & CFD | 13 | January 29, 2013 03:35 |
Error reading trn file | OliH | CFX | 3 | March 4, 2010 09:24 |
Error when reading res file | Taewon Seo | CFX | 1 | April 28, 2009 10:09 |
Error reading msh file | ANIL | FLUENT | 1 | January 22, 2009 01:45 |
Error reading msh file into Fluent | Ralf Schmidt | FLUENT | 5 | October 30, 2005 21:00 |