|
[Sponsors] |
October 30, 2005, 03:45 |
how to expend the table
|
#1 |
Guest
Posts: n/a
|
when i define a table, there are only 500 lines can be used, sometimes the dsta are exceed 500, how can we expend the table. another question: if the data in table as following: time V 1000 2 1000 0
these data means when time is 1000- the velosity is 2 m/s, and when time is 1000+ the velosity is 0, that is the velosity changes at time 1000. is this definition right? if the data in table as following: time V 1000 2 1000 0 the data shown talbe is that the velosity between time 1000 and 2000 is decrease linearly, if we want the velosity to be 0 after time 1000, how can we settle it? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
design table | Nick Sessions | FloEFD, FloWorks & FloTHERM | 0 | October 7, 2008 17:00 |
Table Manipulation | furkan | Siemens | 0 | April 4, 2006 11:23 |
h(t,p)-Table | amu | CFX | 0 | January 16, 2006 09:43 |
RGP table | Atit Koonsrisuk | CFX | 1 | January 10, 2004 12:14 |
use table | Moon | Siemens | 6 | September 18, 2003 09:58 |