|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi everyone , I have a weird problem... my results are not converging even after the residuals go below the max tolerance....I`m using SMPISO whith residual tolerance of 1e-4. Any help is greatly appreciated......
-kc |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
give up the residual tolerance, and translate to the average mass/heat flux on import section
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
URF and convergence in natural convergence | Marie-Anne | Main CFD Forum | 11 | September 11, 2009 10:07 |
convergence | vijay | FLUENT | 6 | February 1, 2006 03:04 |
convergence | vijay | Main CFD Forum | 1 | January 30, 2006 13:13 |
too bad convergence | Davoche | Main CFD Forum | 2 | November 20, 2005 05:08 |
About convergence | LQ | CFX | 3 | June 2, 2005 23:43 |