Home > Forums > Software User Forums > Siemens

StarCcm, refining grid along surface edges

Mark Forums Read

Reply

Search this Thread

June 13, 2007, 06:23	StarCcm, refining grid along surface edges	#1
nico Guest Posts: n/a	Hello, How can I refine my grid (put more cells) along the edges of my surface? Volume shapes work OK. But what i am looking for is something that is linked to my curves (on the edge). In Icem this option works great. Anything similar (that I havent found) in starccm?. The only other option is to link the volume shapes to the curves using java macros. Regards, Nico

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] Refining Mesh	vishal	OpenFOAM Meshing & Mesh Conversion	0	September 25, 2008 09:16
Defining a surface from points or edges in CFXpost	Gui	CFX	9	July 26, 2007 16:12
Defining a surface from edges or points in CFXpost	Gui	CFX	0	July 25, 2007 17:03
Refining mesh	Atholl	FLUENT	2	February 19, 2002 07:38
Dead cells created on edges when a grid file is generated in GAMBIT and imported into FLUENT4	Isaac Manohar Ch.	FLUENT	1	June 2, 2000 05:58

All times are GMT -4. The time now is 10:52.