Home > Forums > Software User Forums > Siemens

PROAM: Problem in mesh generation

Mark Forums Read

Reply

Search this Thread

March 5, 2008, 05:53	PROAM: Problem in mesh generation	#1
Bala Guest Posts: n/a	Hello all, For an external flow analysis with a very large subsurface thickness, after mesh generation its placing cells only in the subsurface thickness otherwise inside the geometry. How to specify in PROAM to place the cells between the external domain and the subsurface???

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mesh generation problem	Ellen	FLUENT	7	February 18, 2009 21:20
problem in mesh generation-PROAM	Bala	Siemens	0	February 21, 2008 04:27
mesh generation problem	giyong	Siemens	2	May 12, 2007 09:08
Problem with mesh generation	Nestor	FLUENT	3	November 1, 2006 02:54
Mesh generation problem	Lam	FLUENT	2	December 25, 2003 12:37

All times are GMT -4. The time now is 21:04.