|
[Sponsors] |
Can parrallel model be run in sequential mode? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 3, 2008, 11:29 |
Can parrallel model be run in sequential mode?
|
#1 |
Guest
Posts: n/a
|
Hi all,
I have the task to re-run a parallel model (with usr subroutines), but I dont have parallel licences. Is it possible to run a parallel model directly in sequential mode without changing anything? I found during the trial calculation that there are warnings about the boundaries and the injection model is not evoked at all(no fuel injected), different from previous results. Where shall I make the modification? Thanks in advance. Mepgzzi |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Icem tetra - Running in parrallel? | Joe | CFX | 5 | September 9, 2006 12:37 |
Parrallel solver | Andrea | CFX | 2 | May 23, 2004 00:49 |
sequential execution of fluent | giorgia | FLUENT | 0 | April 12, 2003 04:45 |
Sequential calculation of Temperature and mass tra | J.W.Ryu | FLUENT | 7 | June 18, 2002 07:12 |
sequential batch run | jy | FLUENT | 2 | August 2, 2000 11:41 |