|
[Sponsors] |
Average values from transient result in StarCCM+ |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 16, 2009, 08:47 |
Average values from transient result in StarCCM+
|
#1 |
Guest
Posts: n/a
|
In transient case ,I want average scalar values at wall from all timestep. So I could export data to FEA Analysis.
Thanks in advance |
|
January 17, 2009, 23:42 |
Re: Average values from transient result in StarCC
|
#2 |
Guest
Posts: n/a
|
This can have two answers:
1. If you want the average over the whole surface as each timestep, then create an area average report of the scalar then a monitor from that report (change storage from iteration to timestep), then export the monitor at the end of the solve. 2. If you want the average value at each location (cell face or presentation grid) on the wall over the whole run then the only way I can think of is to export a table (create the table from the wall locations or a pres. grid) of values at each time step then write a little program to read each of these and average each location. |
|
January 19, 2009, 10:15 |
Re: Average values from transient result in StarCC
|
#3 |
Guest
Posts: n/a
|
Thanks, I think second option is better
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to get average values? | pa-Hung | FLUENT | 6 | July 6, 2020 12:06 |
How do i calculate an average result from a transi | cfxr | CFX | 1 | April 18, 2008 12:12 |
Spanwise average in StarCCM+ | Subhadeep Gan | Siemens | 3 | April 12, 2007 21:46 |
average values in fluent | sankar | FLUENT | 0 | July 11, 2006 23:04 |
Average values | robert | CFX | 3 | December 12, 2005 03:50 |