|
[Sponsors] |
September 20, 2019, 08:43 |
Drivaer Car Model filling
|
#1 |
New Member
Sabal Bista
Join Date: Aug 2019
Location: Canada
Posts: 6
Rep Power: 6 |
I'm trying to simulate air flow around Drivaer model in ANSYS but geometry is created using surfaces and it is hollow inside. Making an enclosure in the symmetry plane shows error. Is there any way to solidify the model in workbench?
|
|
Tags |
ansys, drivaer |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 07:18 |
Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
Rotate (yaw) car model in wind tunnel domain | wcchan2 | FLUENT | 0 | October 23, 2013 00:52 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
drag calculation of a car model by phoenics | mukut | Phoenics | 2 | January 9, 2010 18:07 |