|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Sabal Bista
Join Date: Aug 2019
Location: Canada
Posts: 6
Rep Power: 7 ![]() |
I'm trying to simulate air flow around Drivaer model in ANSYS but geometry is created using surfaces and it is hollow inside. Making an enclosure in the symmetry plane shows error. Is there any way to solidify the model in workbench?
|
|
![]() |
![]() |
![]() |
Tags |
ansys, drivaer |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 08:18 |
Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
Rotate (yaw) car model in wind tunnel domain | wcchan2 | FLUENT | 0 | October 23, 2013 01:52 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
drag calculation of a car model by phoenics | mukut | Phoenics | 2 | January 9, 2010 19:07 |