|
[Sponsors] |
March 31, 2013, 21:15 |
Boiling temperature calculation
|
#1 |
New Member
Join Date: Aug 2012
Posts: 1
Rep Power: 0 |
Dear All,
I am current ly writing my mater thesis in CFD and my problem is correlation of temperature calculation from star ccm+ and test results. Problem: We have an diesel engine and it is tested. The critical point in test is much higher than our first calculation (~100 C difference) and we want to make a new simulation approach for those calculations. I need to do some calculations in STAR CCM+ and derive the best parameters for it. I am using both Rohsenow and Transition model for two phase boiling problem. But somehow, I cannot get close to the measured values in test and the difference is about still 30 C in some calculation (I have nearly 100 different sim files with different BC's.) So: I wanto to know how to get more accurate values for boiling problems. In both transition and rohsenow boiling, solid-fluid interface somehow seems to be calculated independent of the formula paramters because when I change the paramters the surface temperature dont change or some tiny changes. looking forward to hearing from you all. |
|
Tags |
boiling, nucleate boiling, transition boiling, two-phase flow |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
whats the cause of error? | immortality | OpenFOAM Running, Solving & CFD | 13 | March 24, 2021 07:15 |
Is wall ajacent temperature equal to conservative temperature of the wall? | shenying0710 | CFX | 8 | January 4, 2013 04:03 |
Free stream temperature in tube wall | saharesobh | FLUENT | 2 | November 19, 2012 07:32 |
Inlet won't apply UDF and has temperature at 0K! | tccruise | Fluent UDF and Scheme Programming | 2 | September 14, 2012 06:08 |
where is the calculation of the temperature field | Tobi | OpenFOAM | 1 | July 30, 2012 10:40 |