|
[Sponsors] |
July 25, 2013, 03:16 |
solid pressure model in star ccm+
|
#1 |
New Member
Join Date: Jul 2013
Posts: 6
Rep Power: 12 |
Dear All,
I am modeling a two phase flow inside the pipe. This is two-phase water and rocks. The sediment of the particle at the bottom of the tube is required to use the solid pressure model (for packing limit 0.6). However, the model does not converge. How can I change the solid pressure model in software? Since this model does not Subroutine. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
How model radiation of both solid wall and fluid£¿ | Harry Qiu | FLUENT | 2 | February 3, 2013 23:04 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Simulation of a Silo | Attesz | CFX | 20 | October 15, 2010 08:11 |