Part import from NX to CCM+

gerrit91 · January 16, 2017, 04:52

Hello,

I am using CCM+ to simulate flow and heat transfer. The simulated geometry is prepared in NX 10 and 11. The transfer of parasolids works fine most of the time.

I am wondering if and how it is possible to transfer a model containing not only "dead" geometry, but as well parametrics (a diameter for example). Does someone already has experience with this topic?

Thanks.

underrelaxed · January 16, 2017, 18:41

The feature you will need is STAR-NX

gerrit91 · January 18, 2017, 10:12

Hello,

thanks a lot for your answer. Are you using this feature?

underrelaxed · January 18, 2017, 12:35

Yes, I do. I like the bidirectional connectivity, and the ability to update parameters.

Sent from my SM-G920T using CFD Online Forum mobile app

gerrit91 · January 19, 2017, 06:07

That sounds great.
Thank you for the information.

January 16, 2017, 04:52	Part import from NX to CCM+	#1
gerrit91 New Member Join Date: Feb 2014 Posts: 4 Rep Power: 12	Hello, I am using CCM+ to simulate flow and heat transfer. The simulated geometry is prepared in NX 10 and 11. The transfer of parasolids works fine most of the time. I am wondering if and how it is possible to transfer a model containing not only "dead" geometry, but as well parametrics (a diameter for example). Does someone already has experience with this topic? Thanks.

January 18, 2017, 12:35		#4
underrelaxed New Member DL Join Date: Jun 2016 Posts: 18 Rep Power: 9	Yes, I do. I like the bidirectional connectivity, and the ability to update parameters. Sent from my SM-G920T using CFD Online Forum mobile app gerrit91 likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] crash sHM	H25E	OpenFOAM Meshing & Mesh Conversion	11	November 10, 2014 11:27
[ICEM] Import mesh from tecplot	1doffys	ANSYS Meshing & Geometry	0	September 29, 2014 23:52
[ANSYS Meshing] Identical meshes in symmetric bodies in multibody part.	aarvay	ANSYS Meshing & Geometry	2	May 11, 2012 11:15
v4 import ccm	star	Siemens	5	February 27, 2009 04:06
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30

January 16, 2017, 18:41		#2
underrelaxed New Member DL Join Date: Jun 2016 Posts: 18 Rep Power: 9	The feature you will need is STAR-NX

January 18, 2017, 10:12		#3
gerrit91 New Member Join Date: Feb 2014 Posts: 4 Rep Power: 12	Hello, thanks a lot for your answer. Are you using this feature?

January 19, 2017, 06:07		#5
gerrit91 New Member Join Date: Feb 2014 Posts: 4 Rep Power: 12	That sounds great. Thank you for the information.