Problem with Axis of rotation in Periodic BC

mohammad · August 31, 2014, 07:12

Hello everyone,

I am simulating a 0.5 deg slice of circular domain with Periodic BC at the sides, simple inlet and outlet. Consider the domain being composed of the "L" section. (See the Figure please)

The problem is that the when I apply the periodic BC to the side walls of the model, the software considers the axis as no-slip wall!!! and I have velocity profile at the axis!!!!

can you please tell me why???

ping · September 2, 2014, 09:45

sounds to me like it is doing the correct thing since you are appling a period rotational interface to those boundaries so there is pipe on the other side of that axis and no wall

mohammad · September 5, 2014, 05:33

To those future readers of this post:

Actually the line is not "Wall"
it's because of the geometry of the problem which creates the velocity profile like wall BC at the center.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rotation Axis in Fluent	arapha	FLUENT	3	November 8, 2016 21:44
OF 1.6 extend. GGI - rotation around two axis - C++ newbie needs help	A.Wendy	OpenFOAM Running, Solving & CFD	1	February 4, 2013 08:05
Axis of rotation for centrifugal compressor	Mattia	FLUENT	4	October 22, 2007 11:05
Problem with periodic boundary layers	Phil	FLUENT	15	October 2, 2000 14:56

September 2, 2014, 09:45		#2
ping Senior Member Ping Join Date: Mar 2009 Posts: 556 Rep Power: 20	sounds to me like it is doing the correct thing since you are appling a period rotational interface to those boundaries so there is pipe on the other side of that axis and no wall

September 5, 2014, 05:33		#3
mohammad Senior Member mohammad Join Date: Dec 2010 Location: UK Posts: 245 Rep Power: 16	To those future readers of this post: Actually the line is not "Wall" it's because of the geometry of the problem which creates the velocity profile like wall BC at the center.