|
[Sponsors] |
November 12, 2014, 11:12 |
Converting to 2D
|
#1 |
New Member
Justin
Join Date: Aug 2014
Posts: 16
Rep Power: 11 |
Hello,
I am trying to convert my mesh of a car in a wind tunnel to 2D. I rotated my region so that the z=0 plane would be through the center. Attached is a picture. After doing this, I still receive a message that there are no boundaries on z=0 plane. Clearly there are boundaries on this plane after the rotation. Anyone know what is going wrong? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Regarding regIOobjectRead.C at line 73 error while converting results to paraview | hhh | OpenFOAM Post-Processing | 5 | November 24, 2016 02:45 |
[CGNS] cgnsToFoam error when converting ICEM mesh | glasenapp | OpenFOAM Meshing & Mesh Conversion | 5 | October 13, 2016 22:37 |
Converting .dwg files to .stl | Sen | Main CFD Forum | 3 | February 14, 2011 05:37 |
Converting Virtual Faces to Real Faces in Gambit | gstraw | Main CFD Forum | 0 | June 19, 2009 07:11 |
converting user-coding in V4 | Karl Mehler | Siemens | 0 | September 28, 2008 15:48 |