|
[Sponsors] |
How to add a sink term to the transport equation for the volume fraction in STAR CCM+ |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 15, 2015, 06:26 |
How to add a sink term to the transport equation for the volume fraction in STAR CCM+
|
#1 |
New Member
weilai
Join Date: Sep 2015
Posts: 6
Rep Power: 11 |
As mentioned in a paper "An undesired phenomenon that is often observed in hull simulations is a thin layer of air in the first cell layers at the hull surface. This air layer, which affects the shear stresses on the hull, emerges from the region where the free surface hits the hull. It is not observed in experiments, and any air layer forming in the first cell layers at the hull should therefore be removed. In STAR-CCM+ a sink term was added to the transport equation for the volume fraction. The sink term was applied in the cells closest to the hull where the volume fraction of air was below 0.3.", I met the same problem and am new to STAR-CCM+. I want to know how to add a sink term to the transport equation for the volume fraction.
TX SO MUCH! |
|
June 1, 2016, 16:31 |
|
#2 |
New Member
Jochen
Join Date: Apr 2016
Posts: 4
Rep Power: 10 |
Have the same question did you found a solution?
|
|
March 8, 2021, 12:47 |
|
#3 |
New Member
Gokhan
Join Date: Dec 2020
Location: Stockholm
Posts: 5
Rep Power: 5 |
I have the same problem too. If anyone figured it out, may write the solution?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
turbulent diffusion term in transport equation for additional variables | Raijin Thunderkeg | CFX | 2 | May 17, 2014 23:53 |
Is it possible to use divergence in the source term of an scalar transport equation? | jannnesss | CFX | 0 | January 8, 2010 20:53 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Add source term in species equation | zhou1 | FLUENT | 1 | October 21, 2003 07:28 |