How to add a sink term to the transport equation for the volume fraction in STAR CCM+

ASLAN_1987 · September 15, 2015, 05:26

As mentioned in a paper "An undesired phenomenon that is often observed in hull simulations is a thin layer of air in the first cell layers at the hull surface. This air layer, which affects the shear stresses on the hull, emerges from the region where the free surface hits the hull. It is not observed in experiments, and any air layer forming in the first cell layers at the hull should therefore be removed. In STAR-CCM+ a sink term was added to the transport equation for the volume fraction. The sink term was applied in the cells closest to the hull where the volume fraction of air was below 0.3.", I met the same problem and am new to STAR-CCM+. I want to know how to add a sink term to the transport equation for the volume fraction.
TX SO MUCH!

josch · June 1, 2016, 15:31

Have the same question did you found a solution?

GC94 · March 8, 2021, 11:47

I have the same problem too. If anyone figured it out, may write the solution?

September 15, 2015, 05:26	How to add a sink term to the transport equation for the volume fraction in STAR CCM+	#1
ASLAN_1987 New Member weilai Join Date: Sep 2015 Posts: 6 Rep Power: 10	As mentioned in a paper "An undesired phenomenon that is often observed in hull simulations is a thin layer of air in the first cell layers at the hull surface. This air layer, which affects the shear stresses on the hull, emerges from the region where the free surface hits the hull. It is not observed in experiments, and any air layer forming in the first cell layers at the hull should therefore be removed. In STAR-CCM+ a sink term was added to the transport equation for the volume fraction. The sink term was applied in the cells closest to the hull where the volume fraction of air was below 0.3.", I met the same problem and am new to STAR-CCM+. I want to know how to add a sink term to the transport equation for the volume fraction. TX SO MUCH!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
turbulent diffusion term in transport equation for additional variables	Raijin Thunderkeg	CFX	2	May 17, 2014 22:53
Is it possible to use divergence in the source term of an scalar transport equation?	jannnesss	CFX	0	January 8, 2010 19:53
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Add source term in species equation	zhou1	FLUENT	1	October 21, 2003 06:28

June 1, 2016, 15:31		#2
josch New Member Jochen Join Date: Apr 2016 Posts: 4 Rep Power: 10	Have the same question did you found a solution?

March 8, 2021, 11:47		#3
GC94 New Member Gokhan Join Date: Dec 2020 Location: Stockholm Posts: 5 Rep Power: 5	I have the same problem too. If anyone figured it out, may write the solution?