 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2015, 05:11
|
"No FvBoundary found"
|
#1 |
|
Member
Join Date: Oct 2015
Posts: 47
Rep Power: 10  |
Hi folks,
While trying to run a simulation on one of my models I got the following error: "No FvBoundary found for boundary: Outlet_V" What does this mean? How can I fix it? Thanks! Jambond |
|
|
|
|
|
October 19, 2015, 10:54
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
It means you have a part surface which is not assigned to a boundary or its mesh has become corrupted. Check that that part surface exists, has faces, and is assigned to a boundary.
|
|
|
|
|
|
|
October 20, 2015, 08:41
|
|
#3 |
|
Member
Join Date: Oct 2015
Posts: 47
Rep Power: 10 |
Thanks for your reply
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compilation Error: "no matching function for call to ‘div(Foam::volScalarField&)’" | abhiv | OpenFOAM Programming & Development | 1 | September 30, 2015 02:47 |
| [Gmsh] OpenFoam Error Message: "no cells read from file .msh" | kayla1994 | OpenFOAM Meshing & Mesh Conversion | 1 | July 13, 2015 09:26 |
| Problems using a qsub (PBS) job-scheduler: "no access to tty (Bad file descriptor)" | heliana60 | OpenFOAM Running, Solving & CFD | 4 | January 28, 2015 07:14 |
| Error:"Unable to attach geometry", "no valie bodies" | TheForumLord | ANSYS | 0 | July 1, 2014 06:21 |
| CAVITATION "no CONVERGENCE in non-cavitating flow" | ROOZBEH | FLUENT | 9 | December 1, 2003 02:51 |
Linear Mode
