 |
 |
 |
|
|
|
[Sponsors] | ||||
September 16, 2016, 11:26
|
Explicit Plane Tool
|
#1 |
|
New Member
Edward Kraft
Join Date: Dec 2014
Posts: 11
Rep Power: 11  |
So I'd like to make a section plane based on corner coordinates. I read in the help file that the explicit plane tool allows me to move the corners of a plane and specify coordinates. I can't seem to find this. I've tried selecting Derived Parts > Section > Plane, Constrained, and Arbitrary, but none of those options allow me to move the corners of the plane. Attached is an image of what I am looking for. Thanks for your help!
|
|
|
|
|
|
September 22, 2016, 20:24
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
Constrained plane will let you do this. The image you have here looks like a presentation grid, not a plane section.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| Plane stress and plane strain cases for stress analysis | Sargam05 | OpenFOAM | 0 | May 3, 2013 18:16 |
| Explicit derived plane | Dan Chambers | STAR-CCM+ | 3 | March 4, 2011 07:23 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| plane tool | piyush | FLUENT | 0 | February 8, 2007 12:54 |
Linear Mode
