|
[Sponsors] |
November 28, 2016, 05:21 |
Transient water flow
|
#1 |
Member
sriram
Join Date: Jun 2016
Posts: 48
Rep Power: 9 |
Hi every1
Im working with transient water flow in star CCM+...previously i've verified continuous water,continuous slurry with calculation.But Transient conditions with pulsating velocity (say.2.14 m/s for every 1.4 sec and 0 m/s for every 0.4 sec). I've used a excel table input but the results are not matching. Help any1 Thank You |
|
November 28, 2016, 17:07 |
|
#2 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
If you want help you're going to need to give a lot more detail.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Mass Flow rate in spray water modeling | Behnam Ghadimi | Main CFD Forum | 0 | June 8, 2013 15:48 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Laminar gas flow under slight suction - transient works but not steady | audrey | CFX | 1 | September 8, 2011 19:43 |