|
[Sponsors] |
May 23, 2017, 17:39 |
Table xyz,t
|
#1 |
New Member
Mesut
Join Date: May 2017
Posts: 3
Rep Power: 8 |
I'm working on a compressible flow problem.
Firstly, i'm very new at CFD. I should apply time dependent velocity in inlet. I searched some topics about this and i see that i should use table xyz,t. Is this correct or not? If it's correct, i created a table for just trying this method but i have some errors when i start to run. "non-existent column "null"" where is my fault? I'm sorry if this question is nonsense I hope you can help me. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modifying CFD-Post macro to output a time-varying expression at every timestep | lynnathere | CFX | 0 | December 28, 2015 15:19 |
Run time Selection Mechanism - Some help required to understand | jaswi | OpenFOAM Programming & Development | 3 | October 29, 2015 13:42 |
Problem in3D model processing | mebinitap | OpenFOAM | 2 | December 12, 2014 04:40 |
Installing OpenFoam on windows 7-64 | Dadou | OpenFOAM Installation | 10 | February 11, 2014 16:20 |
Table Manipulation | furkan | Siemens | 0 | April 4, 2006 10:23 |