VOF simulation crashing - caused by outlet boundary?

hxax · September 22, 2018, 10:21

I have a 35 knot VOF simulation of a hydrofoil that keeps crashing when the last part of the "pre simulation wake" is about to hit the outlet boundary. Just before the wake picture is about to settle. I guess it has with reversed flow at the outlet to do. Any tricks to prevent this?

hxax · September 22, 2018, 12:15

....last frames before crash.

hxax · September 22, 2018, 13:43

Solved: Had to enable correctt VOF Wave Damping Boundary Option

BRICE P. · September 26, 2018, 03:23

Quote:

Originally Posted by hxax

Solved: Had to enable correctt VOF Wave Damping Boundary Option

Hello,
Please, i do not understand what you means by that.
You just "Enable Damping" or you choose a "Correct Damping in the Outlet Properties"?

Artemis03 · September 16, 2023, 17:43

Quote:

Originally Posted by hxax

I have a 35 knot VOF simulation of a hydrofoil that keeps crashing when the last part of the "pre simulation wake" is about to hit the outlet boundary. Just before the wake picture is about to settle. I guess it has with reversed flow at the outlet to do. Any tricks to prevent this?

Hi hxax, are there any tutorials on VOF hydofoil simulations for STARCCM+? I would be grateful if you could point me to some resources. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 05:45
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Issues on the simulation of high-speed compressible flow within turbomachinery	dowlee	OpenFOAM Running, Solving & CFD	11	August 6, 2021 06:40
My radial inflow turbine	Abo Anas	CFX	27	May 11, 2018 01:44
boundary condition: problems with outlet at 0.99 atm when doing a trasient simulation	umair64	CFX	1	August 17, 2015 18:11

September 22, 2018, 13:43		#3
hxax New Member Norge Join Date: Nov 2017 Location: Norway Posts: 21 Rep Power: 8	Solved: Had to enable correctt VOF Wave Damping Boundary Option