 |
 |
 |
|
|
|
[Sponsors] | ||||
February 2, 2020, 17:13
|
Tutorial file Lobe Blower
|
#1 |
|
New Member
Cindy Entes
Join Date: Jan 2019
Posts: 1
Rep Power: 0  |
Hi,
I downloaded tutorial files of star ccm+, but i cannot find in the .zip archive which corresponds to the last tutorial of motion section named 'Overset Mesh Small Gap Modeling: Lobe Blower'. The name of the file with the mesh that I need and I don't have is: 'lobeBlower.ccm'. If anyone has this file and could send me by email I will appreciate it a lot. Last edited by cacaca6969; February 12, 2020 at 07:04. |
|
|
|
|
|
March 4, 2021, 07:35
|
You need to eat more manguitos maracatones
|
#2 |
|
New Member
Primo Luka
Join Date: Mar 2021
Location: Santo Domingo
Posts: 1
Rep Power: 0 |
Wellington Quiw ya te lo dijo
Ya tu sabe |
|
|
|
|
|
 |
| Tags |
| starccm+, tutorial |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
| [swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0 | towanda | OpenFOAM Community Contributions | 6 | September 5, 2015 21:03 |
| centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 01:41 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Linear Mode
