|
[Sponsors] |
problem with directed mesh using one sided geometric volume distribution |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 13, 2021, 06:21 |
problem with directed mesh using one sided geometric volume distribution
|
#1 |
New Member
Join Date: Dec 2019
Posts: 1
Rep Power: 0 |
hello, my friends.
I meet a problem in directed mesh. I want to meshing a half cylinder with one sided geometric volume distribution. but the result is bad. the mesh on the meridian plane is distorted. it's nomal when I change to one sided hyperbolic volume mesh. but I want using one sided geometric volume distribution. so I need some help. thank you in advance. |
|
Tags |
one sided geometric |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
SU2-7.0.1 on ubuntu 18.04 | hyunko | SU2 Installation | 7 | March 16, 2020 04:37 |
[snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 09:42 |
Mesh is doing some problem | prwl120 | FLUENT | 2 | May 21, 2015 14:05 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |