|
[Sponsors] |
August 12, 2011, 05:00 |
How can i create this :-)
|
#1 |
Senior Member
Join Date: Dec 2010
Posts: 135
Rep Power: 15 |
Hi
How can i create the streamlines just on the blade like on the picture in the attachement? They should also be just filled and show the velocity in radial&tangential direction |
|
August 14, 2011, 22:30 |
|
#2 |
Senior Member
Ping
Join Date: Mar 2009
Posts: 556
Rep Power: 20 |
not sure you can do that plot exactly at present - the lines can be added as a derived part of type Constrained Streamline, but adding the little arrows is not available that I can see. However to show local flow direction you could create a new derived part of type Cell Surface, use the constrained streamline as the input part, then add this to a vector displayer in the scene, then fiddle with vector colour, length, on ratio etc to get something useful.
|
|
June 20, 2021, 01:41 |
|
#3 |
New Member
Shamik
Join Date: Jun 2021
Posts: 2
Rep Power: 0 |
hello Ping..
Thank you for you input regarding the plotting of the constrained streamlines. I wanted to plot something similar over my blade. So I chose the balde surface as the input part but I am not able to chose the part seed. Can you please tell me what should I choose in the part seed? Because my streamlines are looking very odd.. Please refer the attached figure |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing a Sphere | Ajay | FLUENT | 10 | September 3, 2016 14:18 |
[blockMesh] Include list of points | Hikachu | OpenFOAM Meshing & Mesh Conversion | 0 | June 20, 2011 09:03 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |