|
[Sponsors] |
March 8, 2022, 23:02 |
is this flow unsteady? (Star-CCM+)
|
#1 |
New Member
Join Date: Feb 2022
Posts: 6
Rep Power: 4 |
Hello everyone,
I ran a steady k-epsilon turbulent airflow simulation around a 10-meter tall cube. Some of the results I got converged, some didn't. When I look at the flow, it doesn't look like Von Karman Vortex Street either. Can I tell if this simulation has to be done in unsteady conditions? I am adding some pictures from the results for you to tell the difference. I am not that experienced, so I am not sure. https://imgur.com/a/CJGwGe2 Thanks in advance! |
|
April 29, 2022, 10:41 |
|
#2 |
New Member
Evelyn Rodriguez
Join Date: Apr 2022
Posts: 3
Rep Power: 4 |
maybe I can understand you better if there is a photo attached? because apparently there was an error and the files were not attached, please check
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
Periodic boundary in unsteady flow | ac2011 | FLUENT | 0 | September 26, 2011 06:52 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |