|
[Sponsors] |
September 17, 2022, 14:36 |
reference pressure
|
#1 |
New Member
seunghyeon, yun
Join Date: Apr 2018
Posts: 18
Rep Power: 8 |
Hello everyone
I'm confused the reference pressure. I have a regulator simulation and boundary condition like below. Inlet: 100 bar(using stagnation inlet) Outlet: 10 bar(using pressure outlet) Physics - Coupled Flow - Real Gas - Redlich-Kwong - SST (Menter) K-Omega - Three Dimensional ... The reference pressure is default value(101325 Pa). I think that reason of poor Tke(xxe02) is the reference pressure. But, I'm confused... What should I do? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] Not found many .so files when installing OpenFOAM 6 | lengjun | OpenFOAM Installation | 2 | December 12, 2022 22:08 |
viscosity udf don't use correct temperature and strain rate | rezvani | Fluent UDF and Scheme Programming | 8 | May 27, 2021 05:40 |
Domain Reference Pressure and mass flow inlet boundary | AdidaKK | CFX | 75 | August 20, 2018 05:37 |
reference pressure and compressible flow | bingo10 | CFX | 0 | September 11, 2013 07:32 |
OpenFOAM 1.6-ext git installation on Ubuntu 11.10 x64 | Attesz | OpenFOAM Installation | 45 | January 13, 2012 12:38 |