|
[Sponsors] |
June 1, 2023, 14:24 |
Centre of Buoyancy star ccm+
|
#1 |
New Member
Shebi Khanz
Join Date: Jun 2023
Posts: 3
Rep Power: 2 |
Hi there, I am basically doing simulation on underwater UUV. Since for a fully submerged body, the centre of volume is the centre of buoyancy. And I want to take center of mass 0.1m below than center of buoyancy. In star ccm+ DFBI, we can only give center of mass. How will I tell the software about my Center of Buoyancy.Does the software automatically take the center of buoyancy?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem when imported geometry from 3D CAD to star ccm, | TAREK GANAT | STAR-CCM+ | 1 | May 21, 2013 22:15 |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
error in star ccm | maurizio | Siemens | 3 | October 16, 2007 05:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |