|
[Sponsors] |
August 8, 2023, 08:44 |
Unable to get combustion going
|
#1 |
New Member
Sunderam Nagar
Join Date: Jul 2023
Posts: 2
Rep Power: 0 |
Hi All, I'm using a mixture of ammonia and hydrogen and placed an ignitor at the mouth of the inlet and using spark plus timings as 0.03sec and 0.02 sec respectively, however, I'm unable to see any combustion taking place. Any help on this regard would be highly appreciated.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to use UDF/DPM to conduct combustion of boron particles? | Mike08 | Fluent UDF and Scheme Programming | 0 | April 19, 2023 09:55 |
Fluent Parallelization Problem After AC Power Dropped | pawl | Hardware | 5 | November 13, 2016 06:08 |
Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 04:10 |
How to make a code parallel? | Bruno Machado | Fluent UDF and Scheme Programming | 15 | May 27, 2016 09:18 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |