|
[Sponsors] |
September 8, 2010, 06:59 |
GT-Power - Star-CCM+ Coupling
|
#1 |
Member
|
Hello,
I'm trying to couple GT-Power and Star-CCM+ (my versions are avaible for that) and I have no experience for that. Has someone a tutorial about this topic ? Or can someone give me some tipps about this subject ? Thank you in advance Best regards |
|
September 13, 2010, 07:28 |
|
#2 |
Member
|
I have tried to simulate the coupling but there are some errors in my simulation because it diverged.
Without the coupling the CCM+ and the GTPower Simulation worked good. Why are there this errors ? How can I couple the iteration of the 2 software ? Must I have a smaller step because Star-CCM+ is the master in this coupling or not ? Has somebody an example for this coupling ? Thank you |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
A genearl question on STAR CCM | nstar | STAR-CCM+ | 5 | June 24, 2009 09:39 |
error in star ccm | maurizio | Siemens | 3 | October 16, 2007 05:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |