|
[Sponsors] |
April 28, 2011, 08:28 |
Aerodynamic simulation
|
#1 |
New Member
Michele
Join Date: Apr 2011
Posts: 17
Rep Power: 15 |
Hi everybody,
I have to make an aerodynamic simulation, how can I build a control volume (such as a wind tunnel)after importing the geometry I have to simulate? then, once I have made this system (body + wind tunnel) which is the best way to operate: give solid properties to body and fluid to control volume, or make a boolean operation to subtract body from control volume and give fluid properties to the resulting volume? thank you! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aerodynamic simulation | Amech1423 | Fidelity CFD | 1 | June 5, 2011 06:13 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 10:44 |
GUI crash and simulation engine still running | RPJones | FLOW-3D | 2 | November 9, 2010 08:18 |
velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 18:57 |
strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 13:02 |