Pressure gradient

M10 · April 25, 2012, 12:28

Hi,

I'm running airfoil simulations and noticing that I'm not getting enough pressure gradient on the foil surface - thus weak/delayed stall + lower than expected drag on some cases. I'm running k-wSST at Re = 1e5.

Any good ideas or know parameters I can tinker with to solve the problem?

Thank you.
M.S.

ryancoe · April 26, 2012, 10:51

I would take a close look at your boundary layer mesh (overall thickness and y+ specifically) and see how it compares to published work of similar problems (lots of stuff out there).

Hope this helps.

April 25, 2012, 12:28	Pressure gradient	#1
M10 New Member Mio S Join Date: Oct 2011 Posts: 4 Rep Power: 14	Hi, I'm running airfoil simulations and noticing that I'm not getting enough pressure gradient on the foil surface - thus weak/delayed stall + lower than expected drag on some cases. I'm running k-wSST at Re = 1e5. Any good ideas or know parameters I can tinker with to solve the problem? Thank you. M.S.

April 26, 2012, 10:51		#2
ryancoe Member Ryan Coe Join Date: Jun 2010 Location: Albuquerque, NM Posts: 98 Rep Power: 15	I would take a close look at your boundary layer mesh (overall thickness and y+ specifically) and see how it compares to published work of similar problems (lots of stuff out there). Hope this helps. __________________ Ryan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pressure Outlet Guage pressure	Mohsin	FLUENT	36	April 29, 2016 17:16
lid-driven cavity in matlab using BiCGStab	Don456	Main CFD Forum	1	January 19, 2012 15:00
steam flow in a pipe driven by a pressure gradient between inlet and outlet	SalvoCalvo	COMSOL	0	March 11, 2010 06:52
Inputting pressure gradient in Fluent	Josyula	FLUENT	2	December 23, 2009 07:26
Hydrostatic pressure gradient	Craig Finch (Finch)	OpenFOAM Running, Solving & CFD	10	February 28, 2007 23:02