|
[Sponsors] |
dynamic response to a concentrated harmonic force in ABAQUS |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 16, 2017, 08:10 |
Dynamic response to a concentrated harmonic force in ABAQUS
|
#1 |
Member
Join Date: Apr 2016
Posts: 34
Rep Power: 10 |
Hi everyone,
I am not an expert in structural analysis, but I need the data out of the structural simulation for my CFD analysis. I am using ABAQUS for this study and the problem is quite simple. I have a concentrated sinusoidal force (F=a sin( omega*t)) exerted on a node and all I need is the velocity of the surface node for a few cycles. I need to know what is the best type of "ABAQUS step" for this purpose (acceptable acuracy+ not too computationally expensive). I don't know which of these steps is the most suitable for this application (Steady-state dynamic, dynamic explicit or dynamic implicit). Any suggestions? Thanks a lot. Last edited by Eman.; November 16, 2017 at 11:53. |
|
Tags |
abaqus, abaqus cae |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ActuatorDiskExplicitForce in OF2.1. Help | be_inspired | OpenFOAM Programming & Development | 10 | September 14, 2018 11:12 |
how to calculate force with dynamic pressure | T.Matrix | OpenFOAM Post-Processing | 0 | October 14, 2012 00:39 |
wrong transient solution in different time steps of Dynamic mesh | esicia | FLUENT | 7 | February 26, 2012 13:27 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 22:03 |
DEFINE_CG_MOTION and pressure force | Teo Fumagalli | FLUENT | 0 | April 11, 2008 10:25 |