|
[Sponsors] |
September 30, 2018, 11:48 |
Writibg Result File... hanging so long
|
#1 |
New Member
Dmitry
Join Date: Sep 2018
Posts: 6
Rep Power: 7 |
Hello.
I have some kind of problem. Using "path" in Commands I get a 2D-array of some value (z deflection) in a face of a body after a calculation and via *MWRITE saving results in a text file. I don't know why after Preparing and Solving in condition of Writing ANSYS thinks so long. The blue bar is full-length, but it takes a lot of time when it really finishes. How to make it faster? |
|
October 24, 2018, 06:21 |
|
#2 |
Senior Member
Gwenael H.
Join Date: Mar 2011
Location: Switzerland
Posts: 392
Rep Power: 20 |
Hi Dmitry,
It's hard to say without any further information about your model. But in general it depends on the size of your model and how much data you want to export. Also if you're using the standard *get command its way less efficient as the vector operation *vget. Have fun |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] How to use finite area method in official OpenFOAM 2.2.0? | Detian Liu | OpenFOAM Meshing & Mesh Conversion | 4 | November 3, 2015 03:04 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
"parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
Missing math.h header | Travis | FLUENT | 4 | January 15, 2009 11:48 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |