 |
 |
 |
|
|
|
[Sponsors] | ||||
July 23, 2022, 13:50
|
Unit problem with Finite Element Modeler
|
#1 |
|
New Member
Khanh-Duy Cong Do
Join Date: Jul 2022
Posts: 1
Rep Power: 0  |
Hello Everyone!
I have an issue regarding FE Modeler; I created a mesh on ICEM and then use FEM to change the type to the one accepted by transient structural, but when the transformation took place the size of the mesh is reduced, it reduced from 1 m to 1 mm does somebody knows how to correct this?. Thanks in advance! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issues With Exporting From GMSH | rberdon | Mesh Generation & Pre-Processing | 0 | February 11, 2021 11:11 |
| Identifying Markers in a CGNS Mesh | tjim | SU2 | 3 | October 12, 2018 01:21 |
| [Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 05:29 |
| How can be calculate a surface integral in the finite element method? | HectorRedal | Main CFD Forum | 3 | March 13, 2015 08:25 |
| Control Volume , Finite Volume, Finite Control Volume, Finite Element Method | technocrat.prakash | Main CFD Forum | 1 | April 24, 2010 19:24 |
Linear Mode
