|
[Sponsors] |
Different initial conditions for different parts in transient thermal simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 28, 2022, 05:29 |
Different initial conditions for different parts in transient thermal simulation
|
#1 |
New Member
Join Date: Apr 2022
Posts: 9
Rep Power: 4 |
Hello everyone
I am trying to run a thermal simulation to capture the temperature profile at the contact between 2 bodies. Picture1.png I would like to have different initial conditions for the bodies. The attached picture is a section view of the geometry. The grey-colored part should be at 30degC and the blue, green, and orange parts to be at 57degC. Once the initial conditions are set, I would like to run a transient thermal simulation to observe the temperate transfer without any boundary conditions. Can someone please help how I can achieve this? Please inform me if more setup details are needed. Kind Regards |
|
Tags |
ansys workbench, fem, thermal analysis |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help sought on axial compressor simulation | jyotir | OpenFOAM Running, Solving & CFD | 0 | November 17, 2021 11:49 |
pressure in incompressible solvers e.g. simpleFoam | chrizzl | OpenFOAM Running, Solving & CFD | 13 | March 28, 2017 06:49 |
simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 03:20 |
SLTS+rhoPisoFoam: what is rDeltaT??? | nileshjrane | OpenFOAM Running, Solving & CFD | 4 | February 25, 2013 05:13 |
pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |