 |
 |
 |
|
|
|
[Sponsors] | ||||
Let's make an open-source user-guide for SU2? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 22, 2017, 11:59
|
Let's make an open-source user-guide for SU2?
|
#1 |
|
Member
tom pratt
Join Date: Jan 2016
Posts: 55
Rep Power: 10  |
Hi All,
After being asked for an introduction to SU2 by many colleagues and friends, i thought it might be nice to make a generalised step by step guide to optimising custom geometries; not just the 'test case' series. I have made a start on what is as yet a badly formatted but brief and general step-by-step guide to getting SU2 running, attached. But i thought why not open it up to this community in the hopes that together, by building it a little at a time, we could all produce a comprehensive 'general guide to SU2 optimization'. Thanks for reading and i hope you'll consider contributing. Best Wishes, Tom SU2GUIDE.txt |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom Thermophysical Properties | wsmith02 | OpenFOAM | 4 | June 1, 2023 14:30 |
| [swak4Foam] swak4foam for OpenFOAM 4.0 | mnikku | OpenFOAM Community Contributions | 80 | May 17, 2022 08:06 |
| [foam-extend.org] Problems installing foam-extend-4.0 on openSUSE 42.2 and Ubuntu 16.04 | ordinary | OpenFOAM Installation | 19 | September 3, 2019 18:13 |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
| [swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
Linear Mode
