Output flow file for v2.0.2

kevinholst · March 24, 2013, 20:14

It appears that the flow.* output file for this development release is not working properly. The code produces a flow.dat file that looks like a TECPLOT file even if you specify PARAVIEW, and I can't seem to get it to read in Paraview. Is there a work around for this?

Thanks,

Kevin

shirazbj · March 24, 2013, 21:03

i think the paraview vtk part is commented out.

you'd better use VisIt 2.6 to read the tecplot file flow.dat.

economon · March 26, 2013, 15:58

Hi guys,

We are in the middle of an overhaul on the solution output formats. We are no longer supporting the Paraview format directly, rather we will be supporting Tecplot ASCII (.dat), Tecplot binary (.plt), and CGNS (.cgns, an open format that can be used with most visualization packages, including Paraview).

Look for more updates as we go. Cheers,
Tom

March 24, 2013, 20:14	Output flow file for v2.0.2	#1
kevinholst New Member Kevin Holst Join Date: Nov 2012 Posts: 4 Rep Power: 14	It appears that the flow.* output file for this development release is not working properly. The code produces a flow.dat file that looks like a TECPLOT file even if you specify PARAVIEW, and I can't seem to get it to read in Paraview. Is there a work around for this? Thanks, Kevin

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] Error installing swak4Foam	Hisham	OpenFOAM Community Contributions	182	February 8, 2024 11:36
parallel code	samiam1000	SU2	3	March 25, 2013 05:55
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 15:11
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 05:26
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00

March 24, 2013, 21:03		#2
shirazbj Senior Member Cean Join Date: Feb 2010 Posts: 128 Rep Power: 16	i think the paraview vtk part is commented out. you'd better use VisIt 2.6 to read the tecplot file flow.dat.

March 26, 2013, 15:58		#3
economon Super Moderator Thomas D. Economon Join Date: Jan 2013 Location: Stanford, CA Posts: 271 Rep Power: 15	Hi guys, We are in the middle of an overhaul on the solution output formats. We are no longer supporting the Paraview format directly, rather we will be supporting Tecplot ASCII (.dat), Tecplot binary (.plt), and CGNS (.cgns, an open format that can be used with most visualization packages, including Paraview). Look for more updates as we go. Cheers, Tom