|
[Sponsors] |
June 8, 2016, 15:10 |
cgns prism mesh
|
#1 |
New Member
Join Date: Jun 2016
Posts: 1
Rep Power: 0 |
I am running a simple internal flow case with two different CGNS meshes.
I have successfully run the all hex mesh. However, the Hybrid mesh (tets + prisms) case starts to run fine, but it crashes when writing the first solution file. I have changed the "WRT_SOL_FREQ" and each time it crashes exactly at value of "WRT_SOL_FREQ". Any solution to this problem ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] Large mesh expansion Faktor due to prism layer | myusername | ANSYS Meshing & Geometry | 1 | February 17, 2015 08:31 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |