 |
 |
 |
|
|
|
[Sponsors] | ||||
February 11, 2023, 19:35
|
Segmentation fault in SU2-NEMO
|
#1 |
|
New Member
Join Date: Feb 2023
Posts: 3
Rep Power: 3  |
Hello everybody,
I hope you're spending same great time and not going to smash your heads against the wall, like myself, trying to figure out what's going on. I'm trying to use "nemo-euler" but keep getting immediately segmentation fault. If instead I use simply "euler" as solver everything goes smoothly, without errors. Anyone know what might be the error? I leave the config file and the error one, if they may help finding a solution. Thanks in advance for the help! P.S. edit I added also geo file, just in case. |
|
|
|
|
|
February 11, 2023, 21:23
|
|
#2 |
|
Senior Member
Pedro Gomes
Join Date: Dec 2017
Posts: 465
Rep Power: 13 |
FLUID_MODEL= STANDARD_AIR is a no-go probably. See for example
https://github.com/su2code/SU2/blob/...wedge_ausm.cfg |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 'Signal: Segmentation fault (11)' while running openFoam in Parallel Processing | jaymeen721 | OpenFOAM Running, Solving & CFD | 1 | April 10, 2023 19:17 |
| Segmentation Fault when preprocessing geometry SU2 | Samf | SU2 | 3 | April 5, 2018 12:52 |
| Segmentation fault in SU2 V5.0 | ygd | SU2 | 2 | March 1, 2017 04:38 |
| Segmentation fault when running in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 8, 2015 08:12 |
| segmentation fault when installing OF-2.1.1 on a cluster | Rebecca513 | OpenFOAM Installation | 9 | July 31, 2012 15:06 |
Linear Mode
