[bgulzar22]

Hello community! I’m currently working on simulating flow over a cylinder with a catalytic wall using the SU2 solver. I have a few questions regarding the setup, configuration, validation, and slip flow regime. Any insights or guidance would be greatly appreciated!

Questions:

Cylinder Flow Setup:

1. How should I modify my configuration file to simulate flow over a cylinder with a catalytic wall?
2. Are there any specific considerations for the following
3. SUPERCATALYTIC_WALL_COMPOSITION= (1, 0,0)
4. CATALYTIC_EFFICIENCY= 0.2?

Validation:

1. What validation cases or benchmark results can I compare my simulation against to ensure accuracy?
2. Are there any recommended test cases for flow over a cylinder with a catalytic wall?

Slip Flow Regime:

1. If I want to simulate the slip flow regime, how can I adjust the Knudsen number in SU2?
2. Are there any other parameters I need to modify to accurately capture slip flow effects?