How to plot velocity and Mach contour on a blade surface in spanwise direction?

Saima · April 21, 2014, 12:23

Hello Guys,

I am doing flow analysis of a blade in CFX and wanted to plot Mach contour and velocity profile on blade surface in span wise direction.

Guide me how to do that in tech plot?

Regards,

scott_rumage · April 22, 2014, 11:59

Here is a link to a nice step by step tutorial on Tecplot’s web-site that may provide the answer to your question: http://download.tecplot.com/360/tutorials/external-flow/index.html . The tutorial does a nice job of showing the Tecplot 360 user paradigm using a specific example of flow over a wing.
BTW – the video does show an older Tecplot 360 interface, but the steps are basically the same for recent versions as well.

April 21, 2014, 12:23	How to plot velocity and Mach contour on a blade surface in spanwise direction?	#1
Saima Senior Member Saima Join Date: Apr 2009 Location: Canada Posts: 185 Rep Power: 17	Hello Guys, I am doing flow analysis of a blade in CFX and wanted to plot Mach contour and velocity profile on blade surface in span wise direction. Guide me how to do that in tech plot? Regards, __________________ Best Redards, Saima

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mach Contour on water vapor compressible flow	Tony	FLUENT	4	July 15, 2010 12:20
non-dimensional analysis in Fluent	Endee	FLUENT	8	September 7, 2005 17:16

April 22, 2014, 11:59		#2
scott_rumage Senior Member Scott Rumage Join Date: May 2009 Location: Seattle, WA Posts: 152 Rep Power: 18	Here is a link to a nice step by step tutorial on Tecplot’s web-site that may provide the answer to your question: http://download.tecplot.com/360/tutorials/external-flow/index.html . The tutorial does a nice job of showing the Tecplot 360 user paradigm using a specific example of flow over a wing. BTW – the video does show an older Tecplot 360 interface, but the steps are basically the same for recent versions as well.